axis - AXIS LinuxCNC Graphical User Interface
axis -ini INIFILE
axis is one of the Graphical User Interfaces (GUI) for LinuxCNC. It gets run by the runscript usually.
INIFILE
The INI file is the main piece of an LinuxCNC configuration. It is not the entire configuration; there are various other files that go with it (NML files, HAL files, TBL files, VAR files). It is, however, the most important one, because it is the file that holds the configuration together. It can adjust a lot of parameters itself, but it also tells LinuxCNC which other files to load and use.
linuxcnc(1)
Much more information about LinuxCNC and HAL is available in the LinuxCNC and HAL User Manuals, found at /usr/share/doc/LinuxCNC/.
None known at this time.
This man page written by Alex Joni, as part of the LinuxCNC project.
Report bugs at https://github.com/LinuxCNC/linuxcnc/issues.
Copyright © 2007 Alex Joni.
This is free software; see the source for copying conditions. There is NO warranty; not even for MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.